What's different about tree work in Belton?
Belton is the county seat of Bell County, which was formed on Jan. 22, 1850 (Handbook of Texas, checked Nov 15, 2026), and it's the one nearby city found to have a written tree permit that reaches home lots. On a developed lot in a residential district, Belton's Design Standards (April 2014, amended June 2016) protect only designated Belton Heritage Trees: a live oak 36 inches or more across, for example, a pecan of 34 inches, a cedar elm of 25 inches, a post oak of 24 inches or a Shumard red oak of 21 inches. Removing one takes a Belton Heritage Tree removal permit and the Planning Director's approval, and where a replacement can't be planted on site, the city charges $100 per inch of diameter (Belton Tree & Site Clearing page and Design Standards, both read Nov 15, 2026). The standards exclude Ashe juniper, hackberry, chinaberry, Chinese tallow and bois d'arc from protection.
The Planning Department is at 333 Water St., (254) 933-5891. The Design Standards PDF linked from Belton's Design Standards page today is the same April 2014 document as amended June 2016, with the same sizes and fee (checked Nov 15, 2026); Planning can confirm them for a specific lot. The full size list is on the tree rules page.
Belton also bounds Fort Hood on the east, along with Belton Lake, according to the Army's 2016 Joint Land Use Study (read Nov 15, 2026). The state law that caps city tree fees, Local Government Code § 212.905, stops short of any property within five miles of a federal military base that the military was using on Dec. 1, 2017 (enrolled H.B. 7, read Nov 15, 2026), so those caps don't protect Belton property within five miles of the post, which includes at least the parts of the city nearest it. A specific lot takes a measurement from the boundary; this site hasn't measured any.
What should Nolanville homeowners know?
Nolanville is one of the towns the Joint Land Use Study names along Fort Hood's southern boundary, with Killeen and Harker Heights. As of Nov 15, 2026, a search of Nolanville's code of ordinances for "tree" turns up no permit for removing a tree on a private lot. Its solid-waste rules require brush and limbs to be cut to no more than 3 feet and tied in bundles of 25 pounds or less, with heavier pickups arranged through City Hall (§ 13.02.037). Its burning rule is just as specific. The city's burn permit form (read Nov 15, 2026) cites Sec. 5.03.002 and lists trash, brush, tree limbs, grass, trees and leaves among materials that may not be burned except in an incinerator or a container the Fire Chief approves in writing. The permit is $30, due after approval, and it expires 30 days from the start date. Call 254.698.6335.
What's on the record for Temple?
Temple's Unified Development Code says its landscaping standards don't apply to single-family or duplex homes (Sec. 7.4.2.A, as posted, last amended July 7, 2022), and a read of the full code found no tree removal permit or tree preservation section (checked Nov 15, 2026). The 2016 Joint Land Use Study (read Nov 15, 2026) doesn't name Temple among the cities bordering the post, and no distance was measured, so whether the five-mile exception reaches any of Temple isn't determined. Its recent storm history is clearer. On May 22, 2024, two tornadoes touched down: an EF-2 in west Temple with winds estimated at 120 mph at 6:21 p.m., and an EF-1 on the southeast side at about 95 mph at 6:33 p.m., according to news reports citing the National Weather Service (KXXV, May 22, 2025 anniversary report; WFAA; checked Nov 15, 2026). That date falls inside the incident period of FEMA disaster DR-4781, April 26 to June 5, 2024, which includes Bell County (fema.gov, checked Nov 15, 2026).
What about Salado, Stillhouse Hollow Lake and the south end?
The EF3 tornado of April 12, 2022, known as the Salado tornado, tracked 13.1 miles across this part of the county with peak winds estimated at 165 mph. The worst damage was near FM 2843 and Buttermilk Road; it then moved through South Shore into Union Grove Park and lifted shortly after moving onto Stillhouse Hollow Lake, 3 miles south-southeast of Harker Heights. Twenty-three people were injured, and the survey found many hardwood trees uprooted or snapped and many power poles snapped (NWS Fort Worth, checked Nov 15, 2026).
Stillhouse Hollow Lake sits about 5 miles southwest of Belton on the Lampasas River. The federal government owns it and the U.S. Army Corps of Engineers manages it; construction ran from 1962 to July 1968, and at its conservation pool it covers 6,484 acres, per a 2005 Texas Water Development Board survey (twdb.texas.gov, checked Nov 15, 2026). Dana Peak Park, on Comanche Gap Road with a Harker Heights address, describes much of the lake area as forested, with rocky beaches and sandy bluffs along the shore (recreation.gov, checked Nov 15, 2026).
Can you burn brush on rural land in Bell County?
Usually, within limits, and never during a burn ban. Under 30 Tex. Admin. Code § 111.209(4), an owner may burn trees, brush, grass, leaves, branch trimmings and other plant growth on site when the material came only from that property; no state notice or approval is needed (Cornell LII copy of the rule, amended effective Nov. 12, 2020; read Nov 15, 2026). The general conditions in § 111.219, as summarized by Texas A&M AgriLife Extension (August 2020):
- Burn at least 300 feet from any structure holding what the rule calls sensitive receptors, with narrow exceptions such as written approval.
- Start no earlier than an hour after sunrise and finish no later than an hour before sunset.
- Someone stays with the fire.
- Don't burn when winds are forecast below 6 mph or above 23 mph.
Bell County isn't in or next to an ozone nonattainment area on TCEQ's ozone page (updated April 8, 2026; read Nov 15, 2026), so the part of the rule written for counties like Dallas, Harris and Bexar isn't the one that applies here. Inside a city, its own ordinance controls. And the county can shut it all down: KWTX reported on Oct. 6, 2025 that the county judge had issued an emergency order halting outdoor burning countywide from Oct. 7 to 14, after Emergency Management counted 42 grass and wildland fires in seven days (KWTX news, checked Nov 15, 2026). Check for a current ban the day you plan to burn.
How do the county's two landscapes affect tree work?
The Balcones Escarpment runs southeast to northwest through roughly the middle of Bell County, and the Handbook of Texas describes two different counties on either side of it (revised Sept. 30, 2026, checked Nov 15, 2026):
- The western half, Grand Prairie. Rolling uplands cut by stream valleys, some with stony slopes and steep bluffs; loamy and clayey soils with limy subsoils, and shallow, stony soils in places. Native cover includes tall grasses and oak, juniper, pine and mesquite. Harker Heights, Killeen and Nolanville are on this side.
- The eastern half, Blackland Prairie. Mostly level to gently rolling, with dark blackland soils, Houston Black clay the most common. Long farmed, it stays wooded along the streams, with hardwoods. The Texas Water Development Board calls Houston Black a highly expansive clay that shrinks and swells as moisture changes.
Elevation runs from about 450 feet in the southeast to about 1,200 feet at the western line, and the Leon, Lampasas and Salado rivers meet at Three Forks to form the Little River. For a tree job, the side of the county you're on can shape access, stump grinding and what's under the stump; the stump grinding page goes into that.
Who owns the power lines out in the county?
Oncor serves Harker Heights; the city posts Oncor's Make Ready flyer on its own site. Out in the county, two electric co-ops list Bell among the counties they serve: Heart of Texas Electric Cooperative (Bell, Bosque, Coryell, Falls, Hamilton, McLennan and Milam) and Bartlett Electric Cooperative (Bell, Burleson, Lee, Milam and Williamson; office at 27492 State Highway 95 in Bartlett, (254) 527-3551). Neither page, as read on Nov 15, 2026, says which parts of Bell County it covers. Your bill names your provider; tell the contractor whose line it is if a tree is anywhere near it.
Which other Bell County towns are covered?
The contractor serves the whole county, including Morgan's Point Resort, the village of Salado, Little River-Academy, Troy, Holland, Rogers, the Bell County side of Bartlett, and the unincorporated land between them. Requests from Killeen and Harker Heights have their own pages. Wherever the tree is, call (254) 613-7717 or send the request form with the town and a short description.
Bell County questions
Does Bell County require a permit to cut trees outside city limits?
As of Nov 15, 2026, Bell County's subdivision regulations (adopted Apr 2, 2001; revised Dec 2, 2024) cover platting, roads, drainage and driveway permits and don't mention removing trees. For a specific lot, the County Engineer's office answers land development questions at (254) 933-5275. Burning the brush is regulated by the state rule above (30 Tex. Admin. Code § 111.209) and by county burn bans.
How do I find out whether there's a burn ban today?
Bans are set at the county level; the October 2025 one was an emergency order from the county judge. Check the county's announcements or the Texas A&M Forest Service's burn ban map on the day.
Does the Fort Hood five-mile exception reach Temple?
Not determined either way. The 2016 Joint Land Use Study (read Nov 15, 2026) names Killeen, Harker Heights and Belton as bordering the post, and Nolanville along its southern edge, but not Temple, and this site hasn't measured the distance.
Is oak wilt everywhere in the county?
The Forest Service lists Bell County on its oak wilt map, with more than twenty recorded mortality centers, but its maps are a general reference built from 0.75-mile buffers around those centers, not a survey of every property (TexasOakWilt.org, checked Nov 15, 2026). Treat any oak as worth protecting from February-to-June wounds. See the oak wilt page.
